Bed Level Correction calibration squares - scarring – Others (Archive) – Prusa3D Forum

I made stl with 40mm squares on each side and one in middle to help when setting bed level calibration: To use, I print out initially where one squa

First Layer problems - Inconsistency – Assembly and first prints

Bed Level Correction assistance – Assembly and first prints

Bed Levelling Mod & bed level calibration guide (for Beginners

Bed levelling failed - Page 2 – Assembly and first prints

Level bed, uneven first layer – Hardware, firmware and software

Bad layer after the first corrected layers by the UBL firmware : r

Bed not level after bed level correct – Assembly and first prints