Extra gcode in the files from Cura. - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Hello. I have rebuilt Ender 5. It has been rebuilt so that it has 2 hotends on 1 carriage, and 2 extruders. When it needs to change the hot end, I drive to a corner and prime the new hot end in a purge bucket there. My problem is that I can't get the retract and priming right. Below is the gcode

Moving Object: G Code - UltiMaker Cura - UltiMaker Community of 3D

Cura not slicing Holes. - Improve your 3D prints - UltiMaker

Ultimaker Cura problems with build platform size and overhang

Cura not allowing full print area to used - 3D Printing Stack Exchange

3D Printing Solutions > 3D Printer Store > Ultimaker S5

Ultimaker Cura only shows a job taking 10 minutes when it should

G-Code issue with Cura 4.13.1 - UltiMaker Cura - UltiMaker

G-Code issue with Cura 4.13.1 - UltiMaker Cura - UltiMaker

Ultimaker Cura 4.10 : r/Cura

Order of generated Gcode - UltiMaker Cura - UltiMaker Community of

Can You Get Ultimaker Cura on Android? Explained - 3D Print Gorilla

UltiMaker 2+ Connect 3D Printer

preparing G-code - UltiMaker 3D printers - UltiMaker Community of